Uncategorized

Day 145 More Spent Grain Dog Treats, Ginger Beer Update

Spent Grain Dog Treats and a pile of "crumbles".

Spent Grain Dog Treats and a pile of “crumbles”.

Today, I removed a big bag of spent beer grains from the freezer and put the frozen block on a sheet pan in the oven at 250F. After awhile, I was able to scrape a bunch off of the block…enough to spread out an cover the pan with a good layer. The rest of the block went back in the freezer. I let the grain go for some time, but wasn’t really timing it. It still had some moisture, but it wasn’t very wet.  I let that cool before proceeding with the recipe.

Rather than locating my original recipe, I followed a similar one that I found, but I didn’t check my previous notes…or I would have seen the instructions to wring out excess moisture from the grain through cheesecloth. The recipe was the same otherwise, except for the addition of 1/3 cup honey. Here’s a link to my original post: https://mmmbrews.wordpress.com/2014/08/22/extra-edition-spent-grain-doggie-treats/

The recipe instructions I used today recommended a dough hook attachment to mix the ingredients…it turns out that the batter beater would have done a better job. Even with scraping the sides, there was a little unevenness in the mixing. Because I had baked out a little too much of the grain’s moisture, the “dough” was a little too dry. I pressed it into the pan on top of some parchment paper, scored it and baked at 350F for 45 minutes. It is then supposed to be broken apart and baked another hour or more at 200F until it’s dry. Again, because the grain was fairly dry already, this batch came out done! Unfortunately it’s a bit crumbly…I have a little pile of loose stuff. The honey addition and the crunchiness made it more granola-like…and, yes, I tasted it. A few times. Next time, I need to take the time to read my own notes! I wound up with 1lb 10 oz of treats, not counting the crumbles.

Updating the ginger beer “second runnings”, I’m finally getting some drop in the SG reading. It currently reads 1.039, which gives a current ABV of 3.o4%. It’s still pretty sweet, though, so I’m going to let it go another day or two, cold crash it in the refrigerator and then bottle it. I will probably need to pasteurize it. Anyway…glad to see a substantial movement!

8/23/14  8:00 am Pitched yeast in the muscadine wine this morning.

Rehydrated Montrachet yeast poured into muscadine (future) wine.

Rehydrated Montrachet yeast poured into muscadine (future) wine.

8/23/14  2:00 pm Ginger Beer update: ABV up to 3.68%!

Hard ginger beer sample.

Hard ginger beer sample.

Standard
Uncategorized

Day 143 Bottling Citra Belle Saison

Time to start bottling the Citra Belle Saison.

Time to start bottling the Citra Belle Saison.

I figured about 4.75 gallons for bottling and, using Northern Brewer’s priming calculator, I underestimated (on purpose) a little and used 6.0 ounces of corn sugar. Then, when I racked the beer onto the priming sugar, I only got 4-1/2 gallons. I decided to add a quart of bottled water to make up the difference and keep the priming sugar about right. Somehow, it would up back at the 5 gallon mark! anyway, the FG came out to 1.001, after temperature correction. The OG was 1.047, so we should have 6.04% ABV. I filled 29 twelve ounce bottles and 12 twenty-two ounce bottles.

Here's the bulk of it.

Here’s the bulk of it.

I have to say, when I removed the dry hops bag, after I let it drain, I squeezed it out into a measuring cup and it smells AWESOME! I love the smell of Citra hops! And the little squeezed stuff tasted great, too! I also stuck the the hydrometer sample into the fridge to look at clarity later and sample. So far, it’s looking, smelling and tasting good. First sample bottle should be right after Labor Day.

Also did a little organizing of my “cellar”…such as it is. It’s not an ideal situation, but it’s what I have. A lot of my inventory is comprised of a few of this and a few of that. The Hi-Nelson Saison with Hibiscus and the Citra Belle Saison are the largest quantities and there’s a fair amount of Major Nelson IPA and Strawberry Blonde.

Inventory.

Inventory.

Checked on some local wild grapes today…picked over half of a pound in about 5 minutes. Need to go check my main source…soon!

10:30 pm and I checked the SG on my Second Runnings  Ginger Beer. It is at 1.06 at 72.6F=1.061…just not moving. My last effort is to add 1/2 teaspoon yeast nutrient and pitch the rest of the Champagne yeast, after rehydrating. Everything is all sanitized and back in place…let’s see what happens.

Standard
Uncategorized

Day 140 Pasteurizing Tepache, Bottling Ginger Beer, Racking Cherry Belle Saison

Pasteurizing.

Pasteurizing.

 

I decided to go ahead and pasteurize the Peach-Pineapple Tepache. The test bottle was pretty hard. The sample I tasted was lightly carbonated, but I didn’t want to take a chance of overcarbing. I filled my pressure canner body, with the false bottom, with hot water. I used the bottles to be pasteurized as a measure of how much water to use. This served an additional purpose: warmed the bottles a little before pasteurization. I removed the bottles and put the pot on the stove. I brought the water up to 180F and removed the pot from the heat, placed the bottles in, partially covered with the lid, and set a timer for ten minutes.

Lid mostly covering the bottles.

Lid mostly covering the bottles.

Bottles in, off heat, at 180F

Bottles in, off heat, at 180F

When time was up, I removed the bottles to a towel on the counter to cool.

Pasteurized bottles, cooling.

Pasteurized bottles, cooling.

My next project was to bottle the non-alcoholic ginger beer.

Strained ginger beer (non-alcoholic)

Strained ginger beer (non-alcoholic)

I strained the solids out through a cheesecloth and the used a siphon and bottle wand to fill cleaned/sanitized bottles and capped them. They will need to carb for at least 24 hours and then be pasteurized.I believe this batch is too sweet, but I followed the recipe. I put the ginger and spices back into the fermentation bucket. Since they only sat for 24 hours, I feel like there is more flavor to give. So, I’m making a “second runnings” ginger beer that I am going to allow to ferment and produce alcohol.

"Second Runnings"

“Second Runnings”

I added 4 cups of water and measured the OG at 1.062. I may reduce the sugar a little in future batches.  Anyway, I put the bucket back on the heating pad and wrapped it in the Space Blanket.

Next, I got a quart of Culligan bottled water and boiled it for ten minutes and, while it was boiling, I siphoned the the Cherry Belle Citra Saison into a 1 gallon glass carboy for a tertiary stage, leaving behind the cherries and a little sediment.

Secondary leftovers from the Cherry Belle Citra Saison

Secondary leftovers from the Cherry Belle Citra Saison

The color is really nice and the cherry flavor is good. I think this will benefit from a little aging. After the boiled water chilled in the refrigerator, I topped off the saison to a gallon. It didn’t take the whole quart…maybe a pint. I’ll let this settle for a couple of days and then bottle it.

Racked Cherry Belle Citra Saison, before top-off.

Racked Cherry Belle Citra Saison, before top-off.

As for the main batch of Belle Citra Saison, I did an SG check and it was 1.000 at 83F. That’s 1.003, corrected for temperature. This should be ready to rack to secondary any time. When I do rack it, I’ll be dry hopping with an ounce of citra pellets.

Main Belle Citra Saison hydrometer sample.

Main Belle Citra Saison hydrometer sample.

Standard
Uncategorized

Day 139 Making Ginger Beer, Bottling Tepache, Checking Cherry Belle Citra Saison

Bottled Peach-Pineapple Tepache and a soda bottle to judge carbonation.

Bottled Peach-Pineapple Tepache and a soda bottle to judge carbonation.

Tonight, I knocked out a couple little projects and checked up on one. My micro batch of Cherry Belle Citra Saison has a pretty color from the cherries and I think they’ve given up all they really have to offer. I’m going to rack this brew to tertiary tomorrow to settle for a few days before bottling.

A peek at micro batch Cherry Belle Citra Saison.

A peek at micro batch Cherry Belle Citra Saison.

I went ahead and strained my peach-pineapple tepache…it had a bubbly pellicle covering the surface. I siphoned out from under the surface and through a few layers of cheesecloth. I’m not sure it was necessary, but I feel good about it. The flavor is really nice. It’s sweet and tangy and the spice is coming through nicely.

Peach-Pineapple Tepache sample...sweet. tangy, spiced...good stuff!

Peach-Pineapple Tepache sample…sweet. tangy, spiced…good stuff!

The SG is 1.041 and I feel like it’s time for bottling. So I got that done and filled a soda bottle for carb testing. If it goes like I’m anticipating, I should be pasteurizing Monday morning (about 36 hours).

My other project for tonight was peeling a pound of fresh ginger,

A pound of fresh ginger, skin scraped off.

A pound of fresh ginger, skin scraped off.

 

shredding it in the food processor,

DSC05243

Shredded fresh ginger.

and starting a non-alcoholic ginger beer for my brother in-law who is from Trinidad. I’m using a recipe from a cookbook he brought from Trinidad and it looks very similar to tepache, except it uses freshly grated ginger instead of pineapple skins. Here is the recipe:

Ginger Beer

1 lb fresh ginger, skin scraped off with a spoon, grated

8 cups water

Juice and zest from 1 lime

4 cups granulated sugar

1 stick cinnamon

4 to 6 cloves, whole

Directions: (I have adapted for my bottling procedure) Combine all ingredients in a 2 gallon fermentation bucket and stir to start sugar dissolving.

Ingredients in the fermentation bucket.

Ingredients in the fermentation bucket.

Seal lid and install an airlock. Place in direct sunlight for 1 day. (We are having rain, so I’m putting the bucket on a heating pad overnight and most of tomorrow.) Next day, strain. I assume that this would become alcoholic, if I allowed it to ferment longer, but that’s not the plan for this batch. Sweeten to taste, if necessary. Bottle. (I’m going to top off to a gallon with fresh bottled water to extend the batch a little.) Fill a soda bottle to use for judging carbonation progress. It should take a day or two. Pasteurize and store in a cool, dark place and refrigerate before opening. (Open over a sink or outside just to be safe!)

Standard